SMT TARPN NinoTNC

　RPC Electronics から SMT 版の TARPN NinoTNC を買ってみました。

これです。

特徴は以下になります。
Key Features:
・Fully assembled and tested
・Sized to fit perfectly on a Raspberry Pi 2/3/4
・Easily stack multiple units to support multi-nodes/radios
・Runs standard TARPN NinoTNC firmware (and future updates/releases)
・Capable of over-the-air data rates 1200 AFSK, 2400 APSK, 4800 GFSK and 9600 G3RUH baud
・IL2P Forward Error Correction (FEC) capable for any mentioned data rate
・MiniDIN radio interface (industry standard pinout)
・Standard USB B Connector for interface to computer/host device
・FTDI USB-Serial Interface IC (drivers pre-loaded in all major operating systems)
・Firmware updates are performed via the on-board USB interface when released by Nino KK4HEJ
・Fully configured via on-board DIP switches
・Optional Raspberry Pi Pin Interface
・TTL Interface for direct serial interfacing, not requiring USB
・Audio routing switch to pass receive audio from either 1200 or 9600 baud pins on the MiniDIN radio port (no need to modify your cables)
まずはケーブル作成からですね。